1 Channel DC Long Range Remote Control Gadget Controls Flashing LED to Scare Birds

I want to use the 1 channel remote control to operate flashing LEDs in a tree to scare birds in the evening from roosting.

 It is a good idea to scare birds from roosting in the evening by remote controlling a flashing LED because you must be very furious at noise to spoil your sweet dream or interfere with your other activities. Our suggestion is that you can choose this 1 channel dc triggered long distance remote gadget (Model: 0020491 (S1X-DC-ANT3 & CB-2). The receiver is DC 12V input / output type, the maximum operating current is 10A, and it has a waterproof case and external telescopic antenna, so it can be installed outdoors. You can wiring one flashing LED to output terminals of receiver. And supply power to receiver. Flashing LED can get power from receiver directly. With external extended antenna, this remote gadget will transmit signal up to 2000m (6000ft) in the open field.

There are three working modes for your information. They are Toggle, Momentary and Latched modes.
1. Setting control mode Toggle: Only connect Jumper-2.
Press button A on the transmitter: Turn on the relay, terminal OUT 1 outputs DC power, the flashing LED will keep flashing constantly.
Press button A on the transmitter again: Turn off the relay, terminal OUT 1 stop outputting, there is no flashing from LED.

2. Setting control mode Momentary: Only connect Jumper-1.
Press and hold button A on the transmitter: Turn on the relay, terminal OUT 1 outputs DC power, the flashing LED will keep flashing constantly.
Release button A on the transmitter: Turn off the relay, terminal OUT 1 stop outputting, there is no flashing from LED.

3. Setting control mode Latched: Disconnect Jumper-1 and Jumper-2.
Press button A on the transmitter: Turn on the relay, terminal OUT 1 outputs DC power, the flashing LED will keep flashing constantly.
Press button B on the transmitter: Turn off the relay, terminal OUT 1 stop outputting, there is no flashing from LED.